http://www.microchip.comLEDs have been a mainstay in modern electronics for over 30 years. Their design requirements are common knowledge, and most designers don't ...

Actual microcontrollers have powerful bidirectional I/O ports, and you can use different techniques to fully exploit such capabilities. Recent Design Ideas described the “Charlieplexing” method as an ...

The LM3914 LED bar graph driver was an amazing chip back in the day. Along with the LM3915, its logarithmic cousin, these chips gave a modern look to projects, allowing dancing LEDs to stand in for a ...

The algorithm in this microcontroller design this design drives an LED matrix and provides digital-voltage-readout and bar-like dot displays, showing dots for a graphical output if the input value is ...

This “Product How-To” article focuses how to use a certain product in an embedded system and is written by a company representative. Light-emitting diodes (LEDs) have emerged in recent years as ...

Microcontroller port pins can typically be driven either high or low, or else be put into an "input" or high-impedance state. This circuit uses the three states to drive two separate LEDs with one ...

OSIRE® E3731i intelligent RGB LED enables creation of dynamic color and motion effects across hundreds of LEDs The intelligent RGBi uses a new and license-free Open System Protocol for communication ...

One of the easiest soldering projects to do as a beginner is to solder a resistor to an LED. You can technically put the ...

[Konstantin] had some extra 27C256 EPROMS lying around and decided to use them to animate an 8×8 LED matrix. He’s not only using them to store data, but driving the display with them as well. The chip ...